The Stovebolt Site Forums The Parking Lot Panels 'N Burbs Burb Seats

I was asked to post pics of the 60/40 Ranger seat that I will install in my Burb. I just sat the passenger seat on the floor to illustrate the two position Here's a pic of the seat in a normal seating position.

[img]http://pic10.picturetrail.com/VOL326/687113/1184161/69454028.jpg[/img]

Here's the seat in the most forward position to allow passenger access to the rear seat.
Hope this helps .

[img]http://pic10.picturetrail.com/VOL326/687113/1184161/69454027.jpg[/img]

What year Ranger are they from? I picked up a set of buckets from a mid eighties blazer, but yours look like they will work great too.

Thanks Seon

The Ranger's seats are from a '00. I'm sure Toyota, Nissan, Blazer and S10 would also work. I picked the seats up for $150.

garretthes, you're welcome.

Most of the seats i have looked at for the AD suburban have the 60% side on the passenger side. I prefer the 40% side to be there instead. Unfortunately I think these Tahoe seats are too wide, although they may squeeze in there.

Did the ranger seats mount in the same place or did you have to remove the drivers side box (I think the Task Force Suburbans mount the same way the AD's do)

I have thought of using Tahoe buckets with the integral seat belts, has anyone used those?

Tahoe seats

For my panel, I found some bucket seats out of a late '80s 2-door Isuzu Trooper II. They have a fairly low back, so they still look somewhat like an old truck bucket, but they have headrests. The passenger seat folds forward for access to the back, and I found some inner armrests from a different Trooper that I'm going to mount on my seats. They should look quite nice in my slightly modernized panel.