Winter is Coming
Time to think about winterizing your Bolt.
A good Tech Tip WINTERIZING YOUR TRUCK including a link back to the Forums for additional tips.
I have 2 Carter YF carburetors on hand and wondering if one series is preferred over the other. I am wanting to rebuild both, swap one for my current Rochester B with possiblly selling the second. The numbers are pictured below.
Last edited by TUTS 59; 10/30/20264:07 PM. Reason: Add Images
~ Craig 1958 Viking 4400 "The Book of Thor" Read the story in the DITY 1960 Chevrolet C10 "A Family Heirloom" Follow the story in the DITY Gallery '59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)
If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane
Not sure it helps, but the 964S is for a 216. That's what I have on my truck and it does a good job. With the lower series number, the 787SB is likely also for a 216. Neither probably not the best one if it's going on a 235. The mounting hole spacing on the 964S is smaller than on a 235 manifold and won't physically fit. Jon (carbking) should know and may weigh in with more info.
Kevin 1951 Chevy 3100 work truck Follow this saga in Project Journal Photos 1929 Ford pickup restored from the ground up. | 1929 Ford Special Coupe (First car) Busting rust since the mid-60's If you're smart enough to take it apart, you darn well better be smart enough to put it back together.
These carburetors were on a dual Offenhauser manifold I acquired a while back. I have no idea what they were originally on just that they weren't a matched pair.
~ Craig 1958 Viking 4400 "The Book of Thor" Read the story in the DITY 1960 Chevrolet C10 "A Family Heirloom" Follow the story in the DITY Gallery '59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)
If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane
The 787s was the first production of the YF 216 replacement; the 964s was a later upgrade for the 216.
Both will work; the 964 MIGHT work slightly better.
Either is superior (opinion of the writer) to the Rochester.
Jon
Good carburetion is fuelish hot air The most expensive carburetor is the wrong one you attempt to modify. If you truly believe "one size fits all," try walking a mile in your spouse's shoes! The Carburetor Shop