Talking about products Woolwax and Fluid Film for rust proofing and undercoating. Being from the rust/salt belt always looking for different ideas/ways of fighting off the inevitable. Seems like a good product to get into the cracks and crevices of the pinch welds,seams, channels, and bottom of doors after painting. The only down side is the undercarriage would have to be recoated every so often. What's everyone else using after a panel repair for rust protection? Say like on the under side of a floor pan or inside of the bottom of a door patch panel? Any thoughts or suggestions are welcome...
I have used fluid film in the past and in my opinion it is the best so far .Being cheap I have used home made and they are as good as some store bought mixes and cheap but are difficult to get the right consistency to spray but that is partly because by the time I get around to doing my vehicles it is already starting to get chilly
