I believe I spotted an error in a website's procedure to rebuild a Rochester B, BC, BV. Would someone please look at the attachment and verify? It is so easy to make a mistake.
"Adding CFM to a truck will only help at engine speeds you don't want to use." "I found there was nothing to gain beyond 400 CFM."
The photo that’s says correct is good Don’t block the tiny hole That’s how I find them when I disassemble for rebuild I’ve rebuild two of these this last summer -s
Thanks for responding. I sent a message to the website advising of the error. I'm slowly learning that there is much more to rebuilding a carburetor than reading step by step instructions.
"Adding CFM to a truck will only help at engine speeds you don't want to use." "I found there was nothing to gain beyond 400 CFM."
