Doing a bearing and seal refresh on my '62 SM319 and I didn't notice which direction the thrust washer was facing. It's on the main shaft between the second speed gear and main shaft rear bearing. Do the grooves go toward gear or bearing. Bud
There is not a tool made that if you don't try hard enough you can't break! 1952 3100 261 T5 3.08 Gov Locker
1953 Chevrolet 3100 261 cu inch, sm420, 3.55 rear, torque tube still,omaha orange, still 6 volt, RPO green glass, side carrier spare, all done In the DITY Gallery Video of the 261 running
1964 GMC 1000 305 Big Block V6, sm420, the next cab off restoration
