My question for the group concerns the running board apron. The attached photo shows The apron from the underside. There is a threaded flange at the bottom and a punched hole at the top (where green tape is). Where do these two spots get attached to the frame? Again thanks for any help.
You're missing the running board apron support bracket that goes on the front end of each apron. It bolts to the running board with a carriage bolt (should be a square hole in the running board) and then to the apron with two additional bolts. It doesn't attach to the frame. See Section 11, Sheet 17.00 of the Factory Assembly Manual.
Last edited by klhansen; 02/16/20191:13 AM. Reason: added FAM reference
Kevin 1951 Chevy 3100 work truck Follow this saga in Project Journal Photos 1929 Ford pickup restored from the ground up. | 1929 Ford Special Coupe (First car) Busting rust since the mid-60's If you're smart enough to take it apart, you darn well better be smart enough to put it back together.
