The Stovebolt.com Forums Home | Tech Tips | Gallery | FAQ | Events | Features | Search
Help is a click away!

VEHICLE
INFORMATION
KITS


at the

GM Heritage Center
All the details are here.

Searching the Site - a click away
click here to search
New here ??? Where to start?
Click on image for the lowdown. Where do I go around here?
====
Who's Online Now
4 members (moparguy, Gray_Ghost, Wally / Montana, Youngin' Tut 59), 134 guests, and 4 robots.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums66
Topics128,201
Posts1,057,276
Members48,466
Most Online14,466
Apr 26th, 2026
Step-by-step instructions for pictures in the forums
Brad Allen's photos

AD Chevy Trucks

Pictures galore
Over 6,000 pictures

Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips.

Check them out!

Lots of work on Brad's part ... pure enjoyment (and references) for you!

Big Thanks!

THANKS!

For helping keep this great
old truck web site
on the Internet for

over 30 years!

and not clogged down
with Ads!


Again, thanks!

Previous Thread
Next Thread
Print Thread
Joined: May 2003
Posts: 184
B
'Bolter
'Bolter
B Offline
Joined: May 2003
Posts: 184
A couple of the boards in the wood bed of my 52 1/2 ton have rotted out. The rest of the boards seem to be in good shape. I just noticed that the bad spot is directly above the muffler. Actually I had just parked the truck and was sticking my hand through the hole in the bed, and I could feel the heat from the muffler. Hmmm.
Could the heat from the muffler have caused this? I searched the forum and found some posts about heat shields above the rear axle. My muffler is right behind the driver's seat. I don't think it is real close to the bed, but I haven't measured it. The bed appears to be oak and was replaced a previous owner, so I don't know how old it is, but at least 10 years old (probably more like 20).
Has anyone else had this problem?


My dad always told me, "Don't force it, get a bigger hammer".
Joined: Sep 2001
Posts: 29,270
Bubba - Curmudgeon
Bubba - Curmudgeon
Joined: Sep 2001
Posts: 29,270

Is you muffler strapped to the muffler bracket/hanger that is attached to the frame?

Tail pipe heat shield that you referred to?

Joined: Jun 2009
Posts: 1,596
4
'Bolter
'Bolter
4 Offline
Joined: Jun 2009
Posts: 1,596
I would think that the heat from the muffler would help to remove any moisture from the wood, maybe in your climate that's drying it out too much though?


1946 GMC Pickup - S-10 Frame, 455 Buick, TH400, original patina.

My 46 GMC on Photobucket
Joined: Nov 2011
Posts: 1,611
P
'Bolter
'Bolter
P Offline
Joined: Nov 2011
Posts: 1,611
I agree that if anything, the muffler would dry out and help preserve the wood. I think the left front portion of your bed was the lowest spot wherever the PO parked the truck, and the position of the muffler is just a coincidence. If the bed was replaced with red oak, that species is not very rot resistant and if parked outdoors I would expect advanced degradation after 10-20 years.


1941 Chevy 1 1/2-ton WW2 4x4 dump truck
In the Stovebolt Gallery
Lots more pictures
Joined: May 2003
Posts: 184
B
'Bolter
'Bolter
B Offline
Joined: May 2003
Posts: 184
I looked under my truck today. I don't have that muffler bracket Tim mentioned. The muffler is several inches below the bed; much lower than the exhaust pipe as it goes over the rear axle. I guess I'll just chalk those rotted boards up to old age.
Thanks for all the replies.


My dad always told me, "Don't force it, get a bigger hammer".

Moderated by  klhansen 

Link Copied to Clipboard
Home | FAQ | Gallery | Tech Tips | Events | Features | Search | Hoo-Ya Shop
Powered by UBB.threads™ PHP Forum Software 8.0.0