here is my 292 w/ offset motor mounts and T5 cross member. a simple box 2x3'' gets bolted to the bottom of the re-inforced frame. I agree w/ rdavid
Quote
if you are using the 292 side mounted then you should remove that crossmember and install one where the rear transmission mount goes. as long as you are using a 3point mounting system no problem.
.... which is what i have done. ALL three ARE rubber mounted. wink
For the rubber mounts, I am using the stock T5 (S-10) part as well as two biscuit mounts for the 292 offset side mounts.

http://www.sachserodshop.com/pdf/5.pdf

Buffalo Steve can fabricate the motor mounts for you if needed
http://www.stovebolt.com/bboard/cgi-bin//ultimatebb.cgi?ubb=get_topic;f=2;t=010698#000005

my 3104 shots::
http://s67.photobucket.com/albums/h298/1951otter/?action=view&current=DSC00367.jpg

http://s67.photobucket.com/albums/h298/1951otter/?action=view&current=DSC00313.jpg

http://s67.photobucket.com/albums/h298/1951otter/?action=view&current=579990-R1-016-6A.jpg

http://s67.photobucket.com/albums/h298/1951otter/?action=view&current=579990-R1-016-6A.jpg

http://s67.photobucket.com/albums/h298/1951otter/?action=view&current=579990-R1-020-8A.jpg

hopes this helps you all

Jim & Caroline
The highway is for gamblers, better use your good sense."
Gooday-that's my 1¢ answer due to the lousy economy ~ cause I ain't got - no . mo . doe
Every Shaver | Now Can Snore | Six More Minutes | Than Before ... | Half A Pound for Half a Dollar | Spread On Thin | Above the Collar || BURMA-SHAVE