Originally Posted by Achipmunk
E.O.S..... deifinitely can't go wrong there. So its X3
I was originally going to use EOS, but I read online that they changed the formula a few years ago. I couldn't find anything conclusive whether or not it still had lots of zinc.


Originally Posted by Torker
Oh , And you might change the oil before you drive the wheels off it . The moly break in grease will plug a filter some.

I will definitely change the oil afterward. I was planning on putting a bit (couple ounces) of the lucas break in oil with it with each oil change (Rotella T 30w), just to bump up the zinc. Would that be a good idea?

AND, you just made me remember a few questions I forgot.
I don't have an oil filter on the engine, should I install one before I break in the cam?

EDIT: Should I watch to make sure both the lifters and pushrods are spinning? I assume yes, but never can be too sure.

Last edited by Ferndale53; 12/02/2010 6:56 PM. Reason: add question
1953 Chevy 3600