| |
Click on image for the lowdown. 
====
| | |
1 members (Phak1),
186
guests, and
2
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,110 Posts1,056,242 Members48,437 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | 
#68794 11/18/2006 6:01 AM | Joined: Apr 2006 Posts: 171 Wrench Fetcher | | Wrench Fetcher Joined: Apr 2006 Posts: 171 | Sorry for a barrage of questions, but here goes: 1) I was under my 54 this evening and noticed a small (vent?) hole on the bottom of the housing that surrounds the flywheel. What is the point of this? 2) Is there a way to inspect the flywheel without removing the engine or transmission--like an access panel? For the life of me I can't seem to find the steel ball in the flywheel even though the engine sounds like it is timed well. 3) Looking at the 235 from the passenger-side fender, there are two unused mounting holes in the block just to the left of the draft tube and below & to the right of the coil mounting spot. Any idea what this should be used for? 4) Are there any particular washers suggested for when you re-install the oil pan drain bolt?
I'm learning a lot as I read this site, so thanks in advance [design!] for your help. | | |
|
|
| |
