Hi. I've been away for 2 1/2 years and have finally gotten back to my project. Doing a frame-off on my '50 3100. This is my first ground up. Reworked the frame and upgraded the torque tube rear end with better gears and did a disc brake conversion on the front end. Dropped in a rebuilt 235 out of a '55 Bel Air. Everything mechanically has been rebuilt, repainted and repaired. About 2 years ago I raised up the frame and started the engine and made sure the wheels turned and tranny shifted. For the sheet metal I ran the body panels thru Ready Strip and welded in new metal where needed. My body guy is in the process of painting and reassembling the body. He should drop the truck off next Saturday. I have everything to finish her up except some interior stuff. My question is what should be the next steps to take in finishing this project? Yet to be done is wiring, interior, exterior trim, bumpers, , etc. I've been away from this for so long I'm having trouble getting focus. Thoughts and advice greatly appreciated
