I have a 1965 Chevy PU that I have been working on and off for several years. I had 2” drop spindles put on the front of the truck and wanted to know if anyone reading this might have done the same. I have read several different things saying that if you drop the front end 2” then you are suppose to drop the rear 4”. Is this true? I wanted the truck to be slightly raked but I stress the word slightly. I have purchased new stock springs for the front and a rear replacement spring kit that will lower the rear-end 2” – 3” depending if you use a spacer provided with the kit. I was just looking for some input from someone that has done this already or at least helped someone do it. Any help or advice would be greatly appreciated!!!!!!!!!!