sorry if ya'll have read these already, i may have been in the wrong forum,
i'm about to spend a weekened rebuilding a door (next dry one)
my passenger door sags a bit, requiring slamming to shut. tried adjusting hinges and striker. now figure on rebuilding hinges. are the pins tough to get out or back in? i have a new regulator and newish latch, the striker looks in good shape. also a bolt is spinning free from over tightening it, but i think i can get to the back side from the kick panel vent opening. is lab meatl sufficient to hold it in place? i don't have a welder.
thanks, any help would be great.