Can someone send me a picture, or describe, the correct/factory way to connect the throttle cable (not the accelerator linkage, but the dash throttle button/cable) to the carburetor? I have the cable clamped in the holder and trimmed to fit, but am not sure how to actually connect it.

I could figure out a way easily enough, but I wanted to do it factory correct. The original cable broke from fatigue failure and the end that was connected to the carb is gone.

This is for my '49 3800 with the 235 splasher/Carter W-1.

Thanks,
John

~ John

A kid raised on Hotwheels, Matchbox and Tonka cannot be reasonably expected to own only one vehicle as an adult.

1949 Chevrolet 3804
In the Legacy Gallery | In the Gallery Forum
1973 IH 1310 Dump
1963 Kaiser M38A1
2001 International/AmTran RE3000 "Skoolie"
2014 Ford E-350 4x4 (Quigley)