Originally Posted by Grigg
Originally Posted by padresag
he does have a 700r4 so there is no slip yokes between the joints. all that he has to do is install a new ujoint and put it back in. there would be no wrong way to put the shaft back in. it can be put in one way or 180 degrees and it makes no difference in this application
ron
That's what I'm thinking, but wasn't going to eliminate a slip yoke and or joint phasing problem without seeing a picture or a good description of what he has.

For example, both of these shafts could be assembled wrong http://www.stovebolt.com/techtips/driveline/setup/a.jpg
But one with yokes welded on each end can not be assembled wrong... (unless welded together wrong to start with)

Grigg

right and he said that he had it made so if a pro made it, it should be in alignment," you hope".
ron

http://s908.beta.photobucket.com/user/padresag/library/turned%20works
http://s908.beta.photobucket.com/user/padresag/library/furniture
and a little history of where I come from
http://forum.woodenboat.com/showthread.php?156542-old-boatshop-in-Steveston