Formula1 -
You actually weld it to the back of the intake "log" at the bottom, so it doesn't interfere with the three "elbows" which bolt onto the log. That puts it behind the intake so you don't see it as you look at the intake when it's on the vehicle. I would use threaded aluminum pipe so you can put fitters on each end to set up your water heat with brass, aluminum or stainless tubing.
The only other thing that I would be sure of before you start on this project is that the back carb will clear the firewall. And, it's not just the carb, but whatever kind of air cleaner you use. That is the reason my McGurk is on an engine I have on the engine stand. It would not fit in the engine compartment. Other than that, I should look and function GREAT!!
Joe
