There is no company that makes power steering brackets for these older inline 6's (216, 235, 261) at least that ive seen. More than likely you will have to design and make your own bracket. That's what I'm doing for my 54 235. Im making a bracket to move the alternator to the passenger side and then making another bracket to mount a GM, Dodge or Ford pump where the alt/gen use to be. I was going to try to make both fit on the driver side but it would have been a bit tight as I have a 4bbl intake and dual tube style exhaust headers. Putting the alternator on the passenger side just cleans and unclutters it up. I drew my plans up on AutoCad and then sending them to be water or laser cut out.
What steering setup are you using (box manufacture, ie GM, Toyota, etc) and what pump are you planning to use.
At first I was going to be using a toyota box with a toyota pump so there wasn't a chance to have pressure differences, but have now decided to go with a late gm p/s box that mounts on the outside of the frame towards the front. Im looking at using a Dodge pump as the way it mounts and the location of the mounting holes looks like it will be the easiest to design a bracket for.
Last edited by drummin52; 12/20/2008 1:42 PM.
