| |
Click on image for the lowdown. 
====
| | | Forums66 Topics128,154 Posts1,056,851 Members48,456 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Dec 2007 Posts: 23 Apprentice | | Apprentice Joined: Dec 2007 Posts: 23 | I am installing a sbc/700r setup in my 56 TF. I have installed a 79 Firebird (Camaro) front clip and a 79 FB (Camaro) rear end. I am going to use the FB (Camaro) trans cross member.
I centered the trans tail shaft in the frame and bolted the cross member to the trans mount. I found the the cross member to be off center by almost a half inch. I then measured the pinion center line on the rear axle and discovered the pinion is also offset a half inch between the brake back plates.
What's going on here? Do I offset the tail shaft of the trans to match the rear end?
???
| | |
|
|
| |
