Ok. Here's some pictures.

[img]http://i4.photobucket.com/albums/y105/chipotledude05/IM000209.jpg[/img]

[img]http://i4.photobucket.com/albums/y105/chipotledude05/IM000215.jpg[/img]

As you can see, there is a slight offset. I flipped the factory shims around to tilt the axle up to where it is in the pictures. That seemed to correct the offset by more than half. I think I either need to cut off the perches and weld them on at a higher angle, or buy a set of higher degree shims to correct the low pinion angle. Let me know if I'm on track.

Matt