Hello,

I am finally getting my truck roadworthy again after a head-on collision last June. The '54 235" will start (with difficulty), and run, but I can't seem to get it to idle or time it! Points are good, plugs just cleaned and gapped, new vac advance, new fuel pump. I suspect either stale gas/ varnish in carb or my valve tappet clearances are way off (there does seem to be some noise in the valvetrain). This engine was running great last year before the wreck. Any thoughts/ comments are greatly appreciated.

By the way, any comments on the Pertronix ignition module for stovebolt 6's?

Thanks!

Tyler

1953 3600 Pickup
1946 Fleetline Aerosedan
1948 Hudson Commodore