I know this has been discussed and charlie hardin has a tech tip on the subject as well but I think I am stumped on my wiring hookup. I bought a signal switch from one of the truck parts places and it is not a Signal Stat. This is the one everyone sells for around $25 and is pictured in most of the parts books (Classic and Carters, etc). It has 7 wires, most of which are obvious to hook up. Where I am having problems I think is with the brake light switch hookup. I took the left tail light wire off the brake switch post and ran it to the red line on the signal switch, I then hook the brown line from the signal switch to that open post on the brake light switch. I run a new line to the right tail light and hook it to the orange line. I disconnect the two rear brake lights but leave the two tailights connected. My hot is from the acc on the ignition. I connect the battery and the right brake light is on constantly and the rear lights won't blink and that is with the key off. The parking lights work fine by the way. So with all this said, what have I obviously done wrong to you experts out there? Any ideas??
Last edited by mazzer; 08/21/2008 9:21 PM.
