Can anyone give me some advice on what I believe to be a 235 cubic inch engine in my 39 Chevy 1/2 ton truck. There are 5 holes in the drivers side of the block, 2 are taken with a tube connected between them. The other 3 are as follows:
1 near the top back a few inches from the bell housing
1 on the block directly behind the exhaust pipe, low on block
1 about 2/3 the way back from front of block) just right above the top hole taken by one of the tubes.
I am trying to put the Fram remote oil filter system in but do not know which holes to use. I also need to know which one is for the oil pressure gauge.
Does anyone have a schematic or an idea to use or try.
Thanks
"1fine39"
David
