The Stovebolt Site Forums The Shop Area Engine Shop Carb Base Gasket(s) Question (1954 235ci)

My project came with incorrect manifolds and carburetor, so I have been collecting bits and pieces to eventually make this thing go.

The intake manifold I am now planning to use came with a gasket between the phenolic spacer and the manifold itself.

I would guess that there should also be a gasket between the phenolic spacer and the carburetor base...but I almost think I read somewhere that there should not.

I have tried to find an illustration of the assembly: manifold, gaskets, spacer, carburetor - but have not found one so far.

Should there be two fiber washers gaskets in that stack?

Do the pieces in the photo look to be correct? (I would replace the fiber washer gasket that was between the manifold and the spacer with a new one.)

Thanks!