We test fit the 40/60 split bench seat to the cab. The seat is from an '88 C1500, the width is just about spot on. It's funny that Wayne mentioned adding blocks, that is actually more like a reality now. Linda is little, like 4ft 9 in little. I set the seat up on 2 pieces of 5/4" boards to allow her to se over the dash. I zip tied a couple of pieces of 1' board to the clutch and brake pedal. It was still all that she could do to push the pedals all the way down. She is using just the end of her toe to get full reach. The steering wheel is also obstructing her, I will need to find a smaller wheel that looks correct. I plan to add some 1'' square tubing to the seat mounts and possibly cutting the pedals and adding some material to move them up too.
Last edited by TUTS 59; 04/17/20258:15 PM. Reason: Add Images
~ Craig 1958 Viking 4400 "The Book of Thor" Read the story in the DITY 1960 Chevrolet C10 "A Family Heirloom" Follow the story in the DITY Gallery '59 Apache 31, 327 V8 (0.030 over), Muncie M20 4 Speed, GM 10 Bolt Rear... long term project (30 years and counting)
If you don't like driving yourTruck, you won't drive yourTruck..| Living life in the SLOW lane
