Replacing my 250 IL 6 in the 53 Chevy truck. One of the header’s pipes was cut out & replaced with some kind of bendable pipe. It was used to get around the steering gearbox. It sets on the box so the heat can’t be helping the box. While the motor is out I plant to open it up and clean & replace grease whatever. I was considering putting a new header in but either way I don’t want the pipe rubbing on the box nor being compressed (bent) like it is now. Looking for advice on what to do. I don’t have pipe bending equipment. Do others have this problem and if so what did you do to fix it? Thanks!
Last edited by glennj3; 10/16/20232:07 AM.
1953 Chevy 153A 3/4-ton Working on my project since 2015 Follow along in my DITY
