Drivers side "A" pillar is in temporarily and the door lines up good. But both new front fenders fit well but need to tilt down and back. New inner fenders almost seem too high. Its as low as it will go. I think I'll be OK if I can get the fenders tilted. There is about a 3/4 inch gap at the bottom of each door. Lines up good at the cowl. Everything is a repro excluding the doors. What is the best method to tilt these?
~ BD. "You won't find me in an old folks home" Pioneer Florida Cracker 1958 Apache Stepside 1958 Apache 1/2 ton Panel 1959 Apache 1/2 ton Panel
