You did post that you had acquired the correct fuel valve.

So, GUESSING that I am right:

Invert the bowl cover and allow the float tab to rest on the pin inside the spring of the plunger (DO NOT PRESS ON THE FLOAT).

Measure 9/32 inch from the free end of the float to the surface of the bowl cover without the gasket. Adjust by bending the tab a.k.a. lip of the float. If it floods, try 5/16 instead of 9/32.

While you have the bowl cover off, read the number on the metering rod just below the pigtail.

And after all that, it will probably be me that is surprised! wink

Jon

Last edited by Gdads51; 08/20/2023 2:39 AM.
Good carburetion is fuelish hot air
The most expensive carburetor is the wrong one you attempt to modify.
If you truly believe "one size fits all," try walking a mile in your spouse's shoes!
The Carburetor Shop