I have a question about the brake pedal setup on my 1937 1.5 ton panel. I believe the brake setup stayed the same until at least 1946. On my truck, when I take my foot off the brake, the brake pedal return spring pulls the pedal up until it is stopped by the toe-board. The spring also pulls the master cylinder push rod out of the indent in the master cylinder. It seems like there should be something similar to the rubber stop that is mounted on the toe board for the clutch pedal. The brake pedal also returns much more (3 to 4 inches) than the clutch pedal. I attached pictures of the setup when I got the vehicle and a diagram from the GMC manual. Am I missing a part that would keep the pedal from being returned that far?
