You asked if I removed the U-joint ball cover from the torque tube and I answered no. Then I stated that we could not slide the rear yoke off the driveshaft because there was no room. The torque tube tip was against the floorboard and wouldn’t allowed to pull off the U-joint & yoke.

There were only 2 bolts on each side of the crossmember and one coming up from the bottom for a total of 3 on each side. I didn’t see any extra holes but will look tomorrow.

Thanks Kevin. I appreciate the help

Chuck
1950 Chevy 1/2 ton (all original)
1951 Chevy 1/2 ton (future streetrod)
1941 Chevy coupe
1938 Chevy coupe streetrod