Bolters:
I was cleaning up the original 4 speed rock crusher from Iron Annie my 52-3604, After removing the side cover and PTO I noticed that one of the gears has a chipped tooth. My questions are as follows:
1. Should I repair the gearbox or replace it?
2. If I should repair it where can I get a
replacement gear? If I replace it with an
original what should I expect to pay for one?
3. I've got a BW T5 out of an Astro van that had
a 4.3 liter V6 and mechanical speeometer. The
input shaft aand bearing support are trimmed
to fit my 261. Should be an easy swap.
4. We've replaced the original ring and pinion
with a 3.90:1 from Randy's sooooo
a)What will the final drive ratio be with the
4 speed?
b)What will the final drive ratio be with the
5 speed?
Any assistance/advice would be appreciated.
BuBBAB52.
My sanity has never been questioned, moreover, it has never been mentioned!!!!
