I searched, but did not result in the answer was looking for. I will need new front fenders, my rear fenders are blasted and patched, but will take lots to get to a finish level, so I am considering replacing them. So, I am looking at reproduction fenders.
What can I expect from reproduction fenders in the way of fitment? What have you had to modify to make reproduction panels fit. I have heard lots of horror stories and complaints, but not everybody can be using original metal (even though that seems to be the recommended route).
The rear fenders mate to a flat surface (no radius, no body lines) so short of bolt holes not aligning I would think these might be easier. I have seen videos where they have to take a slice out of the front fender adjacent to the mounting flange to the get the panel gaps to modern standards. I need panels not to rub, but am not looking for a perfect show car restoration. I consider my project to be a ground up reconditioning instead of a ground up restoration of 60+ year old work truck that hopefully can be used again functionally.
Thanks in advance for you reply or you sending me to other links.
