hi guys, yes all the weight need's to be on there.
down to the water in the radiator.
in my shop after i install ms11 set up,i make a brkt, that goes where the shock goes.
place a 2x4 under ms11 cross member, that way
lower a-arms are flat with ground.
i take a pipe weld a bolt on the end of it, that goes thru the top hat, bottom part of pipe drill a hole thru it. put bolt thru a-ram & pipe.
that way the truck is sitting at the ride height
it should be at.
when the truck is done i drive it to the front end shop, he install's the coil's & align the front end.
the spring i put in are for a ms11 v6 with air.
DO NOT CUT THE COIL'S
