I am telling you, I warn and warn and warn about sandblasting panels and I will get over and over "I have done it without a problem".

The bad part is, IF it does get warped it is usually toast, ruined.

Cliff, you could possibly shrink the skins back with a shrinking disc. http://metalshapers.org/101/jkelly/index.html

But without a lot of practice or experience, this is going to pretty tough. Replacing the skins may be the only option. It really isn't that big of a deal, if the new skin is of good quality. I don't know what they are like, any ideas guys????

You would remove the skin as described in the following link. http://www.autobodystore.com/ms3.htm

But at the top you would leave an inch or so below the belt line, cutting it off nice and clean with a cut off disc. Then over lap the lip left with the new skin right up to just under the belt line.

Brian

1948 Chevy Pickup
Chopped and sectioned
owned since 1974 when I was 15.