I have the channel- from Chevies of the 40s I think, its the black windlace style- flexible steel and rubber. NO INSTRUCTIONS, but it appears this channel just extends to the top of the glass on both sides and does not cover the window frame. Will it wedge in OK or will I need to attach it w/some short flat screws? I also have to install door handle ferules and a member has explained that to me using an old lug nut and bolt and adding an Oring on the inside to keep it tight.
I am on a roll- last w/e finally fixed the missing timing mark- yes, a new balancer did the deed, and replaced the 750 CFM carb with a 600, so the SBC now is set to run as it should. George
Last edited by burrpenick; 04/19/2016 3:36 AM.
