Hi folks...
I think this is the right area for this, if not... apoligies .
The driver's side vent window glass on my '65 C10, is 'popping out' at the bottom....
from looking at the pass. side, it seems there is a small stud, or pivot point that is attached to the frame that surriounds the vent glass... then sticks down into a hole thru the rubber gasket, into the frame part that bolts to the door itself... then the vent glass can twist open.
It seems that the piece of metal, that is supposed to be attached the the frame of the vent glass, is lodged in the hole. in the frame that is bolted to the door...
So, the question is... if I get a professional to weld the piece of metal - back to the vent glass frame... is that all it will require?
Also, exactly how does the vent window glass go back into the frame that mounts to the door, after it is fixed?
I imagine I will have to take the window and so forth out... as well as the frame that bolts to the door that holds the vent glass... I have to take the main glass out anyway to replace the plastic rollers, so I figured I would do all of this at once.
Thanks...
-W
