hey guys! I am trying to figure out how the rear wall supports are attached to the cab. I have one that is loose. My drivers side is embedded in some kind of tar. The center one looks as if it is being held in place with some kind of seam sealer at the bottom.
The one that is loose is the passenger side.It does not look as if it was ever held in buy the tar like the drivers side. It is loose at the bottom. My question what was the factory method of holding the supports in place. Here is the link to some pics in my build thread.post#154
http://67-72chevytrucks.com/vboard/showthread.php?p=6826187#post6826187
