PM, I can't show you a picture, but I can thoroughly confuse you with a description... :p
The rubber seal goes on the inside edge of the trim ring with the "bulb" on the back side and the ends meeting at the bottom. The ends of the clips fit into the notch in the outer edge of the trim ring, and the "bent" part of the clips press gently on the rubber. The two "bumps" on the side and bottom clips fit over & under the rubber but are really just there to maintain position; the fit between the headlight retaining ring and the trim ring is what locks the rubber down. One of the clips has a square bend to it; it fits into the slot at the top of the headlight bucket and really doesn't hold the rubber as much as the side/bottom clips.
When you slide the whole assembly over the headlight, the rubber will try to grab the sides of the headlight retainer ring. Spit on it so it slides without popping free of the wire clips, hook the top clip into the notch, and gently slip the bottom edge into place. Set the retaining screw in the bottom and you're done.
