My question is to how to run the wiring to the flasher? I suppose the brake light switch should simply send its output directly to a single brake light wire. The turn signal will need a (fused) positive feed from somewhere under the dash (the switched side of the ignition?) but where does this positive go? Switch and flasher? From where does the indicator light on the signal switch get its power?
I suppose I could figure it all out if I just understood how the flasher functions, and had a lot of time and an extra flasher or two.
Thanks all
Karl
The 3 prong flasher terminals are
X. Power
P. pilot light
L. Designated wire from switch.
I put my fuse between the X post and where I grabbed my power
Trace the pilot light off the switch and put that wire on the P post
How many wires total come off the switch?
