| |
Click on image for the lowdown. 
====
| | | Forums66 Topics128,082 Posts1,056,324 Members48,442 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | 
#72277 01/27/2007 2:02 AM | Joined: Nov 2006 Posts: 25 Junior Member | | Junior Member Joined: Nov 2006 Posts: 25 | I am going to use a powerglide in place of my 3-speed attached to a 250 into a 66 stepside. Was wondering if I can use the same drive shaft. Thanks. | | |
#72278 01/27/2007 6:54 AM | Joined: Apr 2003 Posts: 608 Shop Shark | | Shop Shark Joined: Apr 2003 Posts: 608 | Freds,
Yes you can use the old shaft BUT its gonna need to be cut shorter cause the Powerglide is Longer overall than the original 3speed box.
Also,You will need to change out the front yoke on your driveshaft from the current "coarse" spline slip yoke to a fine spline to match the powerglide output shafts fine teeth.
Regards + good luck | | |
|
|
| |
