| |
Click on image for the lowdown. 
====
| | |
1 members (1 invisible),
105
guests, and
3
robots. | | Key: Admin,
Global Mod,
Mod | | | Forums66 Topics128,024 Posts1,055,395 Members48,422 | | Most Online14,466
Apr 26th, 2026 | | AD Chevy Trucks  Over 6,000 pictures Brad Allen has an awesome collection of Chevrolet factory pictures that he has set up from film strips. Check them out!
Lots of work on Brad's part ... pure enjoyment (and references) for you!
| | THANKS!
For helping keep this great
old truck web site
on the Internet for over 30 years! and not clogged down
with Ads!  Again, thanks!
| | | | Joined: Sep 2011 Posts: 148 Shop Shark | | Shop Shark Joined: Sep 2011 Posts: 148 | I have a 56 bel-air with a 283 hooked up to a power glide. I have started noticing a puddle of trans fluid on the barn floor back where the trans is connected to the drive shaft. Could this be a rear seal going bad? Have never worked on a powerglide before, can the seal be replaced in the car or will I need to drop it out. Thanks for any help guys. | | | | | Joined: Apr 2005 Posts: 2,097 'Bolter | | 'Bolter Joined: Apr 2005 Posts: 2,097 | The seal can be replaced in the car. The driveshaft will have to be removed. The seal is a common part available in most parts stores. That may not fix the problem, however. If the rear bushing is worn the seal likely won't last very long. The rear tail housing of the transmission will need to be removed to replace the bushing.
Fred
1956 3100 Pickup/Red/350/3sp OD/PS/Disc Brakes
1957 Bel Air Sport Coupe/Red/355/TH350/PS/Disc Brakes
2017 Silverado LT Single Cab SB/Black/5.3/6 Speed Trans
1947 Willys CJ2A w/F-Head engine
| | | | | Joined: Feb 2004 Posts: 29,747 Kettle Custodian (pot stirrer) | | Kettle Custodian (pot stirrer) Joined: Feb 2004 Posts: 29,747 | Snap-On makes a bushing puller/installer that can be used with the tailshaft housing in place, but very few shops have them. It has expanding fingers that can be slipped through the bushing with the driveshaft removed, then an internal sleeve is slid into place to expand the fingers. A few taps with a slide hammer removes the bushing, and the same tool is set up to drive a new one into place. A well-equipped transmission shop should have that tool. The high school auto shop where I taught for 30-something years had a set of those pullers.
Jerry
"It is better to be silent and be thought a fool than to speak and eliminate all doubt!" - Abraham Lincoln
Cringe and wail in fear, Eloi- - - - -we Morlocks are on the hunt!
There is nothing noble in being superior to your fellow man; true nobility is being superior to your former self. - Ernest Hemingway
Love your enemies and drive 'em nuts!
| | |
|
|
| |
