Hey fellow bolters... I'm at the point in my 1938 Chevy Panel truck build that I'm ready for some headlights. I have the original headlight buckets and also had previously purchased some new chrome headlight bezels. I did some research and found that originally, the 1938 Chevy trucks had the bucket, a reflector assembly that held the original bulbs, a separate clear lens, seal and bezel. I didn't want to use the reflector setup so I contacted Chevs of the 40s and they suggested their sealed beam headlight gasket kit and standard sealed beam bulbs. I ordered and received these items but now can't figure out how to install them. I was disappointed that there were no instructions with the shipment. The conversion seal that I received has a grooved side and then a round rubber seal. I don't know if the groove is supposed to go around the edge of the headlight or around the edge of the headlight bucket. I've tried both but neither seem to be working. Anyone ever used this seal/gasket from Chev of the 40s? Would very much appreciate any assistance! Have a Great Saturday and with any luck, I'll have headlights installed before the day is over!
