I have a 1946 GMC/Chevy 1/2 Ton.
I have original floor boards and an original cab.
I purchased the truck in pieces so I have not seen how it goes together.

Question 1
--------------------------------------------------------------------------
There is a large rather square piece that clearly sets down on the floor
like a tunnel or tranny cover. This piece fits nicely.

Next there is a more rectangular piece that goes on the lower portion
of the fire wall. All bolt hole line up nicely.

These are the two main floor pieces. I'm not worried about all the little
pedal stuff.

Each piece individually lines up nicely. You can clearly see each bolt hole.

Both piece nicely fit to each other when not in the truck.

My issue is that when in the truck the lower lip of the firewall piece
is a little over an inch away from the front lip of the large main floor piece.

clearly they were meant to go together. I'm wondering if there
is a rubber seal or a brace that I am missing to fill in this gab.

I will try to get pictures later today.



Question 2
--------------------------------------------------------------------------
How does the hood stay on?
I feel I am missing a metal dowel that would run through the center of the two
hood pieces. It looks like the cab has a place for a metal dowel to sit and then have
some type of fastener over it.

I have no idea... I have not seen such a thing. I am just looking at what I have
and making a guess as to how it could be fastened.