Originally Posted by DADS50
Here is an simple drawing I made when I was wiring my 7 wire switch
...click...

It shows how the wires should run

I had problems because I had no labels for the wires I was using
Used Cletus tech tip to figure it out.

The drawing is not specific to your switch but you can see how the wires route.

I used a 3 prong flasher.

that drawging looks mostly like what i have now, except that at the brake light switch, there's two wires attaching, but one goes straight to the lights themselves with a wire connecting it to the flasher, then the other goes to the fuse block, then to the light switch on the dash.

pic showing the brake light wire being split to go to both brake lights (thus causing the turns to jumper to eachother)

pic showing the brake light switch wiring.. wire coming up from the brake light and then connecting to the wire headed to the rear of the truck

pic showing the wiring of the fuse block .. the red wire coming in through the firewall is attached to the black/grey wire, i stuck the wire inline with the fuse block after i tried connecting it to the OTHER wire at the brake light switch. neither way works

Last edited by gmtjr; 09/21/2013 2:37 PM.