Hi All,

Here are some photos of the progress on the front wheel cylinders. After the first evapo-rust bath, the end caps came free and the adjusting bolts are now out. I have put them in the second round evapo-rust bath and this morning I placed a wooden dowel on the pistons and tapped them with moderate force. Three of the four pistons moved in about an 1/8 of an inch. My question is, should I pound these straight through the cylinder and out the other side? Is there a better way of removing the pistons other than hooking up hydraulic pressure?

Front Wheel Cylinders after first Evapo-Rust bath

Front Wheel Cylinders in second Evapo-Rust bath

Attempting to Extract piston from Front Wheel Cylinder using wooden dowel

Thanks!
jose