OldBlue,
Here are a few pics of my font suspension. TCI sold a complete kit for my '39.
Pic
The instructions had me cut out the front motor mount cross member in order to use the rack and pinion.
It might be different on your year of truck.
Side mounts were used to set the engine. Driver side , passenger side motor mounts.
My set up:
1954 235
55 clutch housing
T-5 trans
under the floor brake/clutch set up

The "Trucks" episode mentioned did not cut out the front motor mount. At a later episode they fabricated side motor mounts and set the engine. They are much better then mine.

ClasSix Part 8

I do not know if my engine was raised from the original location but it is together now. From the engine to the rear end.

I hope this helps

Bread
.

Last edited by Bread; 08/18/2013 11:20 PM.
1939 Chevrolet 1/2-Ton
"There and back -- repeat"
Follow the story in the DITY Gallery