I have a 1942 Chevrolet Pickup that I am going to install an EZ wiring harness in it.

There are 4 wires in the harness....Ign Power, Ign Start, Ign Coil and Ign Accessory....

The pickup has the original foot starter that has been converted to 12 volt.

How do I hook up the wires to the ignition switch and starter...

Ign Power to ignition switch
Ign Coil to ignition switch...other end to coil
Ign Accessory to ignition switch...

What do I do with the Ign Start wire..since this is not a key start...and how does the ign power on the ignition switch get its current?

Thanks