I can remember installing that wiring harness as if it was yesterday. Very small writing stamped on the wire that was also smudged most of the time where I was trying to read it, made it hard to read what the wire was powering. I also had two circuits that were only wired on the accessory side that I needed to move on the panel to make it ignition and accessory but that wasn't too bad. I also had to move the wire for the power windows because they were wired for Full Time power which wouldn't have been bad but the switches for the power windows had lighted buttons that would have been on all the time so I changed them to Ignition and accessory power. Over-all I would say it was a good kit....I could have just gotten one that was wrong on those two circuits. I had plenty of wire and never had to lengthen any so that was an added plus.

Joe