Yes, the wrist pin sizes will be the same, no matter what the piston diameter is. At one time, oversize wrist pins were available, to be used by reaming the pin holes oversize, but when the engine was rebored, the wrist pin size went back to standard. Since stovebolt rods clamp onto the pins, there's no wrist pin bushings to deal with in the rods. Go ahead and swap a couple of rods if necessary.
Jerry

"It is better to be silent and be thought a fool than to speak and eliminate all doubt!" - Abraham Lincoln
Cringe and wail in fear, Eloi- - - - -we Morlocks are on the hunt!
There is nothing noble in being superior to your fellow man; true nobility is being superior to your former self. - Ernest Hemingway
Love your enemies and drive 'em nuts!