Thank you all.
Well, I am proud to serve and I am even more proud of you all who support the military service members.
I am still working on painting the chassis and the suspension. Once that is all painted, I'll put it together.
I have a pilot bushing in route so I can put the engine and trans together.
The trans I received already had the mods done to it. The only thing I had done to t it was the two lower holes were threaded.
Once it is time to set the engine, I will need to get a placement for the side motor mounts. I do not want to place the engine so far back to where I have to cut into the firewall but I also do not want to place it forward that the fan hitting the radiator.
From where to where do I measure to in order to make sure that the engine is as close to original placement? I still have the bell housing cross member attached. Also, what is the angle that the engine needs to be at?
The brake pedal I bought from TCI doesn't have a clutch pedal on it. I will either have to find a set up that will accommodate both the brake and clutch or find some way to mod the old brake/clutch setup to fit the brake booster and master brake cylinder. I figured that most people would go with an automatic trans and that is why a single brake pedal kit is sold.
Bread
"The world is a dangerous place, not because of those who do evil, but because of those who look on and do nothing." -Albert Einstein
Last edited by Peggy M; 12/30/2023 12:10 AM.
