The Stovebolt Site Forums The Shop Area Engine Shop 55 2nd series exhaust pipe question

thank you for the help, the pipe goes straight back. I picked up the exhaust system from a place called "Classic Exnaust" I found them on the internet. The exhaust is suppose to be made to OEM specs. But when I recieved the pipes and muffler I noticed that the back part of the pipe that comes out of the muffler and goes over the axle seems to be bent more to the left (towards the center of the frame looking to the rear of the truck) then to the right when I put it on the inside between the shock and axle. But if I run it between the shock and leaf spring it seems to go near the factory hanger. But the pipe looks to cramped when I put it between the shock and leaf spring. When I picked up the truck it did not have the whole exhaust system on it just the front pipe that went to the muffler. And the pipe was held up by a piece of wire. So I was hoping someone may still have a truck with the stock 235 and the stock exhaust and could post a picture of the exhaust where it goes over the axle.